3) A pressure sensor with current output is used to measure the Hight of a liquid in a tank. Then it is used to control the input liquid flow Qin to keep the liquid Hight constant as the liquid flow out from the tank with a flow rate Qout. Draw the block diagram of the control system and define each block. Note: pressure controlled pneumatic actuator is used as a valve.

3) A pressure sensor with current output is used to measure the Hight of a liquid in a tank. Then it is used to control the input liquid flow Qin to keep the liquid Hight constant as the liquid flow out from the tank with a flow rate Qout. Draw the block diagram of the control system and define each block. Note: pressure controlled pneumatic actuator is used as a valve.

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter11: Float Switches

Section: Chapter Questions

Problem 7SQ

See similar textbooks

Similar questions

A) With a neat sketch diagram explain the working of 1 Centre tap full wave rectifier 2 full wave bridge rectifier B) Describe the actions of the following filter circuit 1 capacitor filter 2 choke input filter 3 capacitor input filter
(a) State the types of turbine flow meters and point out the difference between them. (b) What is the advantage and disadvantage of orifice plate flow meter ? (c) State the types of temperature measurement transducers , explain in details the operation and construction of the thermistor (d) Explain in details the bourdon tube pressure sensor and how it operates.
Using neat sketches describe the following terms in brief (a) EKF SLAM (b) Strap down inertial sensor (c) Kalman Filter
Mono stable Multivabrator has unstable state ? Explain briefly
Explain the transducer elements with block diagram and mention the different types of displacement sensors.
Q31Answer the following questions 1.Explain briefly the diode and forward bias and reverse bias of it with drawing? 2.Explain briefly with draw the mechanism of Relay?
Question: A 1-phase voltage controller using two SCRS connected in anti parallel acts as controlled rectifier.The reason is Option 1: Load is R and pulse gating is used Option 2: Load is RL and pulse gating is used Option 3: Load is R and high frequency carrier gating is used Option 4: Load is RL and continuous gating is used
basic electronics pleasy give full answer thanks a) Compare series, shunt and chopper type JFET switch. b) Consider the following circuit. Calculate the output voltage when. Also calculate the on-off ratio
discribe the key step in the design of Control System
is the amount of change in the controlled variable required to run the controlled device from one extreme to the 10. other a- Offset b- Throttling range 11. used to reduce overshoot when a rapid response is desired a- Derivative control b- Proportional control 12. RTDS have a a- Positive temperature coefficient b- Negative temperature coefficient 13. Thermistors have a- Positive temperature coefficient b- Negative temperature coefficient 14. Open loop control is a system with a- No feedback b- with feedback 15. W a- Floating controller b- Potentiometer type controller O this figure refer to R
Comparing the performance with controlled rectifier circuit which one of the following statement is correct for DC -DC chopper ? O a. Regenerative braking process is very slow O b. Efficiency is poor in chopper circuit O c. small filters are required O d. Switching frequency is not responsible for output ripples
a) Figure 3 illustrates a thyristor phase control circuit and associated waveforms. Describe the function of the control element in the circuit towards the output at the load. Identify the best-suited application to describe the control circuit. Lamp Load VAC SCR r 9 8₁ Conduction MM h 18₂ h Gate Trigger Pulse