A positive-sequence, balanced A-connected source supplies a balanced A-connected load. If the impedance per phase of the load is 18 + j12 and I = 9.609/35° A, find LAB and VAB-

Q: b) A 208-V three-phase power system consists of an ideal 208-V Y- connected three-phase generator…

A: it is asked to find the magnitude of line current and load power factor for given 3 phase system

Q: Determine the power density on an earth station from a 5-W satellite source. That is 22,000 mi from…

A: Given : Power of satellite source is 5W. Distance between satellite source and earth station is…

Q: In Example 4.2, given a sequence x(n) for 0 ≤ n ≤ 3, where x(0) = 1, x(1) = 2, x(2) = 3, and x(3) =…

A:

Q: What is the difference between AM-DSB and AM-VSB.

A: In the given questions we need to provide difference between Amplitude modulation based on Double…

Q: A three-phase, Y-connected, 75-MVA, 27-kV synchronous generator has a synchronous reactance of 9.0 Q…

A:

Q: 9.66 For the circuit in Fig. 9.73, calculate Zr and Vab. 60/90° V +1 fo ZT 20 Ω -j5 Ω θα + Vab j10 Ω…

A: For the given circuit calculation of ZT and Vab.

Q: Given a sequence x(n) for 0≤n≤3, where x(0) = 1, x(1) = 2, x(2) = 3, and x(3) = 4, a. Evaluate its…

A:

Q: Please Solve within 40 minutes i Give upvote. Determine the plug setting and % bias setting to…

A:

Q: Explain the working of zener diode

A: We have to explain the working of zener diode.

Q: Q1. The shaft power output of 3-phase, 4 poles, 50Hz induction motor is 32 KW at 1420 rpm,…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub- parts for…

Q: 1.2 For the circuits of Figure 1.2 sketch von 10 V 12 V -10 V 1-12 V f = 1kHz (a) 10x0 m 5.3 V с It…

A: Given data, 1.2) a) b)

Q: It is known that the different equations of a system are as follows: 3y[n - 2] - 2y[n - 1] - 2y[n] =…

A:

Q: Result of the following binary operation is: (0010)2 + (0111)2 + (0100) 2 O (1101) 2 O (1100) ₂ O…

A: Given data, To perform binary operation. 00102+01112+01002

Q: Find the Thevenin Equivalent for the following circuit by finding: • v open circuit; • i short…

A: Given data: circuit diagram is given as:

Q: a) Find the inverse Laplace Transform of: F (s) = 14s+23 s²+5s+4

A: In this question We need to determine the inverse Laplace transform of the given signal.  We know…

Q: b) Consider a mobile handset operating within the new 5G band at 3.4 GHz. Currently the user is…

A: It is difficult to give specific advice on how far the user should move in order to potentially…

Q: 1. For the signal shown below, find: A. the period T. B. the frequency f and the fundamental angular…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: Describe the basic principles of the ultrasonic testing technique;

A: Ultrasonic testing is a non-destructive testing technique that uses high-frequency sound waves to…

Q: Signal

A: Given: Maximum frequency of baseband signal is : fm=46.4 KHz

Q: For the circuit shown in Fig. 9.46, find z eg rad/s. 12/0° V I 492 j20 92 ww -j14 92 16 Ω j25 92 and…

A: For the circuit shown in fig. calculation of Zeg and current I. Let ω=10 rad/sec. For calculation…

Q: Q: Find Z-transform x(n) = 2-"u(-n+1) +0.3 "(-n+2)u(-n)

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: Q/Design a filtered power supply that can produce dc output voltages of (+9 V), (±10%) and (+9 V),…

A: Filtered Power Supply:- The filter circuit should be positioned between the rectifier and the load.…

Q: c) Using = 150 and VBE = 0.7V find Q operating points for Vcc = 10V, RB = {100k, 150k, 200k2},…

A:

Q: Given that I₁=50 mA, I₂=-30 mA, R₁=5 k2, R₂=1k2, R₂=3k2,^R₂=2 ks2. 1. Solve for the voltage across…

A: Given: Current I1 = 50 mA, Current I2 = -30 mA , Resistance R1 = 5 kΩ , Resistance R2 = 1 kΩ ,…

Q: Question No.23 The active power in a delta connected system of 440V with a balanced load of…

A:

Q: Q4. Use the superposition theorem to find the voltage V, in the circuit of Fig. 3 and calculate the…

A: The superposition theorem state that the sum of response of individual sources acting alone is equal…

Q: characteristics of the system function of FIR filters are ( B. have zeros and no poles D. have poles…

A:

Q: Design a 3-bit binary gray code up/down counter using J-K Flip Flops. Draw the state table, state…

A: To do: We have to design a 3-bit binary gray code up/down counter using J-K Flip Flops with state…

Q: Explain single line diagram for industrial power

A:

Q: ▸ Calculate X(k) for the sampled signal x(n)=[ -2 1 -1 2 ], using FFT. Also confirm your results by…

A:

Q: find the value of admittance Y on given circuit diagram

A: Given : Y is the admittance value. Let admittance Y1=14S, Y2=1j8S,Y3=1-j10S.

Q: A co-axial cylindrical capacitor shown in Figure (i) has dielectric with relative permittivity ₁₁ =…

A: Given- Relative permittivity- εr1=2, One-fourth portion of the dielectric is replaced with another…

Q: Use the node-voltage method to find Vo in the circuit Vs-5 cos 1600t V

A:

Q: Using aupstposition, find the voltage across the 6 A source. 12 V 8₁ Www 40 1-6A *120 R₁ www 40 +BV

A:

Q: 7 a Explain what is meant by the contrast in a radiograph and indicate how it can be optimised. b…

A: As per Bartleby guidelines, the first question is solved (7 a) here. Please post the next different…

Q: +5V W 2 ΚΩ -0 V₂ -O V₁ (2 mA –5V

A:

Q: Find I₁ in the circuit in the figure. 2 mA 3 ΚΩ Σ 9 mA 1₁ • 4 ΚΩ 6 mA

A: Given :  Current flows from A to B, IAB = 9 mA, Let Resistance present between point A and D is…

Q: (b) The voltage v(t) = 2t (v) for t>0 v(t) (+ 8Ω 2F (b) Circuit B i(t) (4) What is the current of…

A:

Q: A 480-V, 60 Hz, 400-hp 0.8-PF-leading eight-pole A-connected synchronous motor has a synchronous…

A:

Q: O What noise Voltage will be generated across a 100k resistor under the following conditions? i) T =…

A:

Q: Q2. For the circuit of Fig.2, Find a) The Thevenin equivalent circuit between terminals x-y. The…

A: The thevenin's equivalent circuit can be obtained by calculating the open circuit voltage and…

Q: Outside the United States speed is measured in Kilometers per hour (km/h) rather than miles per hour…

A: Given data: The travelling speed is 160 km/h. The conversion of km/h into mph is done as, 1km/hr =…

Q: A three phase 200MVA, 16kV cylindrical rotor generator has negligible armature resistance and…

A:

Q: The impedances are mesh-connected to a symmetrical three-phase, 40-V, 50, Hz supply of phase…

A: It is given that: Vph=VL=40 Vf=50 HzZ1=(5+j10)ohmZ2=(5+j5)ohmZ3= (6+j4)ohm

Q: For the circuit shown to the right, after the switch is closed, the transient current i (in A) is…

A: Given data, Current it=21+e-0.4t Given circuit,

Q: An unbalanced star-connected load is supplied from symmetrical three-phase mains. The load impedance…

A: Given data, Line Voltage VL=400 V Impedances, Za=j10 ΩZb=-j5 ΩZc=10 Ω

Q: D→ iP

A: Magnetic Field Intensity at the origin due to any part of the circle is given as  B=μ0 I θ4 π Rθ=In…

Q: c) Using = 150, VBE = 0.7V, ro= co find Q operating point employing DC analysis, find re, Zi, Zo, Av…

A: Given: β=150, VBE=0.7 V, r0=∞.

Q: 240 V R ww m C B Data: C = 200 nF; L = 0.8 H; R = 1120 kn Find the voltage across the capacitor…

A: Now it is given that in the previous case the initial voltage across the capacitor is 72 Volts (with…

Q: (1) Design the circuit to reduce the input voltage by 40%, by using the circuit connected through an…

A: As per Bartleby Guidelines, I am solving the first question. Please post other question (Question 2)…

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.