Given the following concentrations of aqueous ions as well as their atomic weight or molecular weight, how much is the permanent hardness in meq/L? Atomic weight or molecular Concentration (mg/L) weight (g/mol) Ca2+ 40 150 mg/L as CaCO3 Mg2+ 24 100 mg/L as CaCO3 Na+ 23 46 mg/L K+ 39 39 mg/L HCO3 61 225 mg/L as CaCO3 96 72 mg/L CI 35.5 71 mg/L О 0.2 0.3 O 0.4 O 0.5

Given the following concentrations of aqueous ions as well as their atomic weight or molecular weight, how much is the permanent hardness in meq/L? Atomic weight or molecular Concentration (mg/L) weight (g/mol) Ca2+ 40 150 mg/L as CaCO3 Mg2+ 24 100 mg/L as CaCO3 Na+ 23 46 mg/L K+ 39 39 mg/L HCO3 61 225 mg/L as CaCO3 96 72 mg/L CI 35.5 71 mg/L О 0.2 0.3 O 0.4 O 0.5

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Draw a bar diagram on your sketch paper based on the table below and determine the non-carbon hardness (permanent hardness) in mg/L of CaCO3. Atomic weight Equivalent weight or molecular Concentration (mg/L) meq/L concentration (mg/meq) weight (g/mol) 100 Ca2+ 40 150 mg/L as CaCO3 150/50=3 (g/mol)/2(eq/mol)=50 Mg2+ 24 100 mg/L as CaCO3 100/50=2 Na* 23 46 mg/L K* 39 39 mg/L HCO3 61 225 mg/L as CaCO3 225/50=4.5 So,2 96 72 mg/L 35.5 71 mg/L O 25 mg/L of CaCO3 O 50 mg/L of CaCO3 O 100 mg/L of CaCO3 O 150 mg/L of CaCO3
A surface water has the following analysis: Ca- 101 mg/L Mg=4.75 mg/L Nat 14.0 mg/L HCO= 220 mg/L so= 88.4 mg/L C= 21.3 mg/L What is the total hardness, carbonate hardness and non-carbonate hardness in mg/l as CaCO? [Atomic weight: Ca 40; Mg = 24.3; Na 23; H 1: C 12:0= 16: 5=32; C=35.5)
Table 2: Absorbance Values of Standards and Unknowns. Sample Blank Standard Solution 1 Standard Solution 2 Standard Solution 3 Standard Solution 4 Standard Solution 5 Water Sample 1 Water Sample 2 Phosphate Concentration (in ppm) Y17 0 ppm 0.02 ppm 0.04 ppm 0.08 ppm 0.16 ppm 0.32 ppm Freeman Lake 0.001 0.325 0.292 0.413 0.315 0.039 0.054 0.049 Absorbance at 2= 690 nm Calculations: 1. Construct a phosphate standard curve in Excel by plotting concentration (in ppm) on your x-axis and Absorbance (unitless) on your y-axis for your known solutions. Label the axes on the graph and provide the curve with a title. Use a linear trendline to generate a best fit line to your data. Label the graph with the equation and the R" value. Insert your labeled graph in the space below. X
Q3/ A/If the concentration of Ca is 56.4 mg/L and of Mg is 8.8 mg L in water, what is the total hardness of the water expressed in mg L of cacos? MW CCO 100.06 243 1201 160
RMR (kcal/day) = (9.99 x 79.5kg) + (6.25 X 182.9cm) - (4.92 x 35) + (166 x 1)- 161
Concentration of Reagents (NH4)2S2O8 KI Na2S2O3 0.25 M 0.22 M 0.19 M Volumes of Solutions S₂082 (mL) Starch soln (mL) KNO3 (mL) EDTA soln (mL) KI (mL) S₂O32- (mL) x 5 9.7 0.9 26.4 0.5 9.9 1.1 Using the above data determine the concentration of I at the moment the reaction begins. HINT: This is a mixing problem. Determine the total number of moles of I and divide this amount by the total volume (in L). Be careful... If you go back and try this exercise again the values will change. Read the question carefully! Answer:
The protein concentration of a protein isolate was determined using the Bradford assay. Five dilution of bovine serum albumin (BSA) were prepared from a 5.00 mg/mL BSA stock solution. To these dilutions, 100 µl of Bradford reagent were added. After 5 minutes, the absorbance was taken at 595 nm. Standard # BSA, in mg/mL Volume of Bradford reagent, A595 in mL 1 5.0 0.000 1.00 5.0 0.134 3 2.00 5.0 0.265 4 3.00 5.0 0.388 4.00 5.0 0.497 The supernatant dilution was prepared by mixing 49 µL of the protein isolate with 16 µL water. The absorbance was taken 5 minutes after addition of 100 mL Bradford reagent. Calculate the protein concentration (in mg/mL) of the original isolate if the absorbance at 595 nm was 0.413. Note: Final answer format must be x.xxx (three decimal places). Round off only in the final answer. Do not round off in the middle of calculation.
3. The following mineral analysis was reported for a water sample taken from a local NJ well. Determine the total, carbonate and non-carbonate hardness in mg/L as CaCO3. Well No. 1, Lab No. 02694, November 9, 1971 Iron 0.2 Silica (SiO2) 20.0 Manganese 0.0 Fluoride 0.35 Ammonium 0.5 Boron 0.1 Sodium 4.7 Nitrate 0.0 Potassium 0.9 Chloride 4.5 Calcium 67.2 Sulfate 29.0 Magnesium 40.0 Alkalinity 284.0 as CACO3 Barium 0.5 pH 7.6 units Note: All reported as "mg/L as the ion" unless stated otherwise. Ca2 Alk Non
Calculate the solubility of PbF, in water at 25 °C. You'll find K data in the ALEKS Data tab. sp Round your answer to 2 significant digits. x10
The Ksp value for calcium sulfate [CaSO4] is 2.40 X 10-5 so if a professor made 1825 mL of a CaSO4lag) solution then how many grams of sulfate (SO42) ion would be present in this solution. 0.8345 gram SO42- ion 0.8588 gram SO42- ion 0.9331 gram SO42- ion 1.0036 gram SO42- ion 0.8921 gram SO42- ion 2.. 591..docx W- LAB EXP. #3 -.docx Show All
A solution of FESCN2+ has a concentration of 1.00 x 10-2M and an absorbance of 0.755. What is the concentration of an FESCN2+ solution with an absorbance of 0.373? Enter your answer in scientific notation, with one decimal place, as follows: 2.3e-4 or 2.3E-4 Do not include units and note that 10 and x are NOT USED in this type of scientific notation.
Part Il: Determination of Standard Solutions mL of 0.200 mL H20 added M Cuso, diluted Tube # M Cuso4-5 H20 added Absorbance about 3 0.200 1.346 3. 4.00 1.00 0.945 4 3.00 2.00 0.715 2.00 3.00 0.469 6. 1.00 4.00 0.281 show calculation for Tube #3 diluted concentration: