TRUE OR FALSE, if false then give the correct word to make the statement true then explain 1. Sublimation occurs when a solid has a relatively high vapor pressure at a temperature [above] its melting point. 2. To isolate the desired chemical, a single extraction is [more efficient] than extracting the compound numerous times. 3. The compounds are separated in liquid-liquid extraction based on their relative solubilities in two [immiscible] liquids.

TRUE OR FALSE, if false then give the correct word to make the statement true then explain 1. Sublimation occurs when a solid has a relatively high vapor pressure at a temperature [above] its melting point. 2. To isolate the desired chemical, a single extraction is [more efficient] than extracting the compound numerous times. 3. The compounds are separated in liquid-liquid extraction based on their relative solubilities in two [immiscible] liquids.

Macroscale and Microscale Organic Experiments

7th Edition

ISBN:9781305577190

Author:Kenneth L. Williamson, Katherine M. Masters

Publisher:Kenneth L. Williamson, Katherine M. Masters

Chapter6: Steam Distillation, Vacuum Distillation, And Sublimation

Section: Chapter Questions

Problem 11Q

See similar textbooks

Similar questions

is a method of purifying a compound by removing any impurities that might be mixed with it. It is often used as a final clean-up step, after other methods that are effective at removing larger amounts of 31. impurities, but that do not raise the purity of the final compound to a sufficiently high level. * Sublimation Recrystallization O Decolorization
Differentiate between simple distillation and fractional distillation. Please elaborate.
Why is water not used as a solvent in extraction of nuts
Which one answer does NOT represent a characteristic of a good recrystallizing solvent? O 1) Should not react with sample. O 2) Should do a poor job of dissolving impurities when hot. O 3) Should have a moderate boiling point. O 4) Should do a good job dissolving a sample when cold.
2. The goal behind suction filtration is to remove soluble impurities that are on the surface of the crystals. Therefore, why can't you simply use suction filtration instead of recrystallization to purify an impure solid?
Part D: Volatiles. A 1.232 gram sample of copper complex weighed 0.783 g after heating. What is the percent of volatile material in this sample? If the sample contains 17.4% ammonia, what is the percent water in the sample?
Unknown compound has a solubility of 0.023 g/mL in water at 20 °C. For the purification by crystallization, 6.5 g of this compound was heated in 100. mL of boiling water and it was completely dissolved. After cooling to 20 °C it was allowed to crystallize until for enough time. Fing the maximum possible amount of crystalls that can be obtained after filtration. 0.23 grams 2.3 grams 2.4 grams 4.2 grams 6.5 grams
A group was given the responsibility of performing a recrystallization experiment in their laboratory to see if the three newly found solvents could purify and separate a mixture including compounds A and B. The following are the solubilities of the two compounds in g/100 mL of hot and cold solvents: Solubility in g/100 mL solvent A B Solvent Hot Cold Hot Cold 1 4.60 1.10 5.30 1.90 2 6.40 5.80 8.40 1.10 3 9.70 3.30 6.80 1.70 What is the %recovery and %purity of A and B in the chosen solvent? Show solutions pls
You were tasked to separate the components of a mixture containing silica, sodium chloride and charcoal. TNāCI dissolves in water while silica and charcoal are not water-soluble. Only charcoal dissolves in carbon disulfide. a. Write a short experimental procedure to carry out the separation of the mixture. b. Given the following data, determine the percentage of charcoal, sodium chloride and silica. Mass (g) Mass of beaker 100.000 Mass of beaker + mixture 110.000 mass of evaporating dish 62.000 mass of evaporating dish + solid after evaporation of water 65.000 Mass of beaker + charcoal + silica after evaporation of excess water 117.000 mass of beaker + silica after decanting dissolved charcoal and drying 113.545
Write TRUE if the BOLD word/phrase makes the statement correct. Otherwise, write the correct WORD/PHRASE that will make the statement true. If there are two bold words/phrases in a number, write your answer for EACH of the bold words/phrases. 1. In the extraction of caffeine, NaOH was added to dry the collected organic layer. 2. Purification of caffeine via sublimation was possible because it has a high sublimation point at a temperature above its melting point. 3. The E/Z designation is used to describe the orientation of identical groups in alkenes.
Q1/Why do we use oil instead of water to determine the melting point of chemicals? Q2/What is the reason for the variation in the measured melting point of the same chemical? Q3/What is the best type of oil used to measure the melting point of chemicals? Why?
C. Identify the method for the separation of the following mixtures: 1. Kerosene in water 2. Iron fillings and wood shavings 3. Water and alcohol 4. Salt solution 5. Powdered chalk in water 6. Soil with gasoline 7. Crude oil processing to separate diesel from gasoline 8. Blood components 9. Sand and water 10, oil and water