Vater (20°C) is pumped through the 300-mm steel pipe from the lower tank to the upper one at a rate of 0.4 m³/s. Given that the pump efficiency is 65% and the pump is on for 5 hours each day, what will be the monthly (30 days) energy cost for the pump if the electricity rate is 0.5 USD per kWh? Elevation = 235 m O 22018 USD O 37234 USD O 61942 USD O 16384 USD Elevation = 200 m 300 mm 100 m 300 mm 10 m 50 m

Vater (20°C) is pumped through the 300-mm steel pipe from the lower tank to the upper one at a rate of 0.4 m³/s. Given that the pump efficiency is 65% and the pump is on for 5 hours each day, what will be the monthly (30 days) energy cost for the pump if the electricity rate is 0.5 USD per kWh? Elevation = 235 m O 22018 USD O 37234 USD O 61942 USD O 16384 USD Elevation = 200 m 300 mm 100 m 300 mm 10 m 50 m

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A pump with an overall efficiency of 60% is pumping an acid (p= 1800kg/m3) from an open tank (atmospheric pressure) to a reactor unit at the rate of (8 square root 8) kg/s. This unit operates at 8000 Pa gauge and the acid is discharged into it with a velocity of 0.24 m/s at a point 6m above the acid surface level in the tank. Determine the power required (kW) to run the pump if the sum of the major and minor energy losses are equivalent to 3m of H2O head.
A one-hectare vegetable farm uses a shallow tube well (STW) for irrigating the crops on the farm. A 10-hp diesel engine is used in lifting water in the said STW. Considering renewable energy as an alternative source of power. Develop a design (draw/sketch) of an energy system using renewable energy to replace or reduce the usage of traditional sources of power.
In a large pumped hydro plant, the head from the turbine to the lake surface is 100m. During a period of 8 hours of excess electricity in the grid the pumped hydro plant pumps water back into the top reservoir. If the combined efficiency of the pump is 70% and the plant has a capacity of 50 MW how much water is pumped back up to the top reservoir? Assume the head remains constant during pumping. A. 0.5 x 10 – 1.0 x 10 m B. 1.1 x 10 – 1.5 x 10° m C. 1.6 x 105 - 2.0 x 10 m D. 2.1 x 10° - 2.5 x 10 m3
A Lassonde Startup Company aims to expand its pump business into rural areas, where accessing clean water from underground wells can be challenging. Often, families struggle to extract water manually from the wells, making it difficult for them to meet their water needs. To address this issue, the marketing team of this Startup Company plans to promote their new centrifugal pumps, which can be installed in wells, making clean water more easily accessible to the local community. Additionally, this initiative will help raise awareness about their company within the region. In the new model of the pump, water leaves the impeller with a velocity of 25 m/s and an acceleration of 30 m/s², measured relative to the impeller along the blade line AB. The impeller rotates at a constant angular velocity ofw = 15 rad/s. 30° a) We need to determine the velocity and acceleration of a water particle at point A as it leaves the impeller at the given instant. (m/s) 100 200 0.3 m b) Shallow wells, dug…
The available flow of water is 25 cu. m/ sec at 30 m elevation. If a hydro electric plant is to be installed with turbine efficiency of 85% and generator efficiency 90%, what maximum power that the plant could generate?
The capacity of a certain pump is 5251 gallons per hour with a capacity of 68.54%. A city uses this pump to extract water from a water supply from a body of water where in the intake is 10.2 ft below the surface of the body of water. A 3-in S40 is used to transfer the water through a pipe with a total length of 8848 ft having a total friction loss of 222.7 (ft-lbf)/lbm. Given that the cost electrical power is 14.7 cents/kWh, what is the hourly pumping cost in cents per hour? Note that in this problem, the inlet to the pump is 35.7 ft above the surface of the body of water while the water level in the tank discharge is always 380 ft above the pump discharge Answer options: 700 557 1175 685 226
A pump draws saturated water from a condenser which is maintained at 32.15°C. The friction head losses between pump and condenser is measured to be 1.5 m. Determine the minimum height of water level (above pump centerline) in the condenser if NPSH required required for the pump is 3.5m Draw the FIGURE
Water is stored in an elevated reservoir. To generate power, water flows from this reservoir down through a large conduit to a turbine and then through a similar-sized conduit. At a point in the conduit 89.5 m above the turbine, the pressure is 172.4 kPa and at a level 5 m below the turbine, the pressure is 89.6 kPa The water flow rate is 0.800ms The output of the shaft the turbine is 658 kW. The water density is 1000 ke m. If the efficiency of the turbine in converting the mechanical energy gven up by the fluid to the turbine shaft is 89 % (n =0.89). a) Draw a schematic diagram for the process b) Calculate the frictional loss in the turbine in J kg %3D
Your second customer wants to determine the required electrical power, which will be used to pump water with the following design specifications: The pump loses 3 kW in the form of heat to its surrounding. The inlet and the exit conditions of the water are as indicated in Figure 2. The pipe diameter is 5 cm. P2 = 150 kPa V2= 1 m/s Z2= 105 m Q- 3 kW Motor Welectrical Water P:= 100 kPa O Vi= 1 m/s Zı= 5 m Figure 2: Schematic for task 2. You must follow the following parts to do your task: Part 1 Derive the steady flow energy equation (SFEE) from the first principles. You are required to show all the steps in deriving the SFEE and using both the principles of mass and energy conversation.
An ice plant owner decided to install a water pump from a nearby clean fresh water source to supply its water requirements. The capacity of the pump is 45.5 cu m per hour against a head of 43 meters with an efficiency of 70% at full load and 40% at half load. The total cost of the pumping unit including the piping system of the plant is P 700,000 with zero salvage value at the end of the its estimated life of 20 years. The prime mover of the pump is an electric motor and cost of power is P2.10 per kwh. Taxes, insurances and maintenance cost is 1.5% of the first cost per year. The pump will operate 200 days continuous operation per year at half load and 150 days at full load. If cost of money is 12%, how much will it cost the owner to operate the pump per cubic meter?
Water is to be pumped from the bottom of a well 20 ft deep with a specific heat of 1 BTU/lbm F is pumped using a 1-hp jet pump. Heat is lost from the whole system at the constant rate of 500 BTU/min. What is the temperature (℉) of the water as it enters the vessel if the flow rate of the water is 5 gal/min?assuming that the well water is at 35℉? kindly show all necessary calculations
Water with a specific heat of 1 BTU/lbm F is pumped using a 1-hp jet pump from a well that is 20 ft deep into a vented water vessel 160 ft above the ground. In the process, 900 BTU/min of heat is lost from the system. What is the temperature (F) of the water as it enters the vessel if the flow rate of the water is 5 gal/min? Assume the temperature of water in the well is (35 F).