Water flows with a discharge of 0,02 through a pipe reducer as is shown in the Figure 1. The static pressures at 1" (D1=0,3 m) and 2nd (D2=0,1 m)cross-sections are measured by the inverted U- tube manometer containing oil of specific gravity, SG as 0,7. Determine the manometer reading, h *(m). (SI Unit System)

Water flows with a discharge of 0,02 through a pipe reducer as is shown in the Figure 1. The static pressures at 1" (D1=0,3 m) and 2nd (D2=0,1 m)cross-sections are measured by the inverted U- tube manometer containing oil of specific gravity, SG as 0,7. Determine the manometer reading, h *(m). (SI Unit System)

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

pls ans asap Water flows at 0.07 cubic meter per second through a pipe. A horizontal venturi meter with throat diameter of 150-mm was used to measure the velocity inside the pipe. Based on manometer reading, the differential gauge is deflected 1.2 meter. If the specific gravity of the manometer fluid is 1.60, the diameter of the pipe, in millimeter (mm), that was used is
A and B are cross-sections of two pipes with water flowing. These pipes look like To measure the pressure difference between A and B by connecting a U manometer is requested. The heights in the U manometer are given in inches (1 inch=25.4mm). Since Moil=850 kg/m3 and 'mercury=13600 kg/m3 A- Find the pressure difference B. B Oil 8 -H20 10 H20 4 3 Hareketli plaka -Hg-
A manometer is an accurate pressure measuring device that is used to measure low pressure in the pipes. Select one: O True O False In a flow channel, the density of fluid at entry is equal to the density of fluid at exit for a compressible fluid. Select one: O True O False 10bar = 1MN/m2 Select one: O True O False
The U Tube manometer is widely used to measure the differencelin pressure between tMo donta in a given flow system. As an example, a manometer connected betweeti pipesA and B is stiowti devermi pressure difference in the two pipes. All dimensions shown are in centimeters. Kerosene Benzene P 20 Mercury Weter
Q1: In a venturemeter used for measuring the flow of oil (S = 0.85) through a horizontal pipeline, the pipe diameter is 2.4 times the diameter at the throat. Connections are made from the entrance to the meter and the throat to a vertical U tube containing mercury. If the difference level between the fluids in the U-tube arms is (x +) in cm, where S.N. is student serial number. Neglect friction in the pipe. Find an expression in terms of x for the velocity of the oil in the pipe. Throat Area, A On, S-0.85 k+(1/S.Nin cm Manometer - Mercury S-136
A 'U' tube differential nanometer connect two pressure pipe A and B. pipe A contain carbon tetrachloride having specific gravity 1.594 under a pressure of 117.72N/cm*2 and pipe B contain oil of specific gravity 0.8 under pressure of 117.72 N/cm*2 . the pipe a lies 2.5 m above pipe B. Find the difference of pressure measured by mercury as fluid filling 'U'tube manometer.
Water flows at 0.07 cubic meter per second through a pipe. A horizontal venturi meter with throat diameter of 150-mm was used to measure the velocity inside the pipe. Based on manometer reading, the differential gauge is deflected 1.2 meter. If the specific gravity of the manometer fluid is 1.60, the velocity, in meter per second (m/s), of water inside the pipe is Blank 1 **EXPRESS YOUR ANSWER IN TWO (2) DECIMAL PLACES**
1. A pressure gauge attached to a pipe is reading 1.34 m of Hg at a place where the atmospheric pressure is 10.33 m of water. The approximate absolute pressure at the mountain isa. 930 kPab. 181 kPac. 280 kPad. 100 kPa 2. The flow is said to be unsteady and non-uniform when,a. The flow velocity is not changing with time but changing with spaceb. The flow velocity is changing with both time and spacec. The flow velocity is changing with time but not changing with spaced. The flow velocity is not changing with both time and space 3. The below figure shows a pipe with a circular cross section of diameter D mm on the left end and a square cross section with side D mm on the right end. Mercury enters the left end with a velocity 1 cm/s and leaves the right end with a velocity V2. Find V2 (neglect losses in the pipe).a. Cannot be find since length is not givenb. Cannot be find since diameter is not givenc. 7.85 mm/sd. 12.73 mm/s 4. 1 kg water is flowing through an inclined pipe at…
Fig shows a U-tube differential manometer connecting two pressure pipes at A and B. Pipe A contains a liquid of specific gravity 1.6 under the pressure of 113 kN/m². The pipe B contains oil of specific gravity 0.6 under the pressure of 203 kN/m?. Find the difference of pressure measured by mercury as fluid filling U-tube in mm. The value of x and y are 2.2 m and 1.2 m respectively. P S X- Mercury The Mercury level difference (h) in mm
Fig shows a U-tube differential manometer connecting two pressure pipes at A and B. Pipe A contains a liquid of specific gravity 1.5 under the pressure of 110 kN/m². The pipe B contains oil of specific gravity 0.5 under the pressure of 216 kN/m². Find the difference of pressure measured by mercury as fluid filling U-tube in mm. The value of x and y are 2.1 m and 1.1 m respectively. Pa S ==<4 INI IN Intercont The Mercury level difference (h) in mm
Fundamental of fluid flow: A venturi meter with a throat diameter of 6 cm is fitted in a horizontal pipeline of 12 cm diameter with oil of specific gravity 0.88 flowing from left to the right. The difference in level in the two limbs of a mercury manometer connected to the tapping points read 12 cm and the connecting pipes are filled with the same oil. (a) If two pressure gauges are fitted at tapping points, one at the throat and the other in the inlet. Determine the difference between the 2 gage pressure readings in kPa. (b) Determine the flow in m^3/s neglecting head losses.
86 N/cm"] 11. A single column vertical manometer (ie., micrometer) is connected to a pipe containing oil of sp. gr. 0.9. The area of the reservoir is 80 times the area of the manometer tube. The reservoir contains mercury of sp. gr. 13.6. The level of mercury in the reservoir is at a height of 30 cm below the centre of the pipe and difference of mercury levels in the reservoir and right linb is 50 cm. Find the pressure in the pipe. (Ans. 6.474 N/em) 12. A pipe contains an oil of sp. gr. 0.8. A differential manometer connected at the two points A and B of the pipe shows a difference in mercury level as 20 cm. Find the difference of pressure at the two paints. [Ans. 25113.6 N/m³) 13. A U-tube differential manometer connects two pressure pipes A and B. Pipe A contains carbon tetrachlo- ride having a specific gravity 1.594 under a pressure of 11.772 N/cm and pipe B contains oil of sp. gr. 0.8 under a pressure of 11.772 N/cm. The pipe A lies 2.5 m above pipe B. Find the difference of…