Find visocisity of whole blood @ 37oC TABLE 4.1Physical Properties of Adult Human BloodPropertyValueWhole BloodpH7.35–7.40Viscosity (37°C)3.0 cP (at high shear rates)Specific gravity (25/4°C)1.056Venous hematocrit-male0.47Venous hematocrit-female0.42Whole blood volume-78 mL kg-' body weightPlasma or SerumColloid osmotic pressure-330 mm H,0pH7.3–7.5Viscosity (37°C)1.2 сРSpecific gravity (25/4°C)1.0239Formed ElementsErythrocytes (RBCS)Specific gravity (25/4°C)1.098Count-male5.4 x 10° mL-' whole bloodCount-female4.8 x 10° mL-' whole bloodAverage life span120 daysProduction rate4.5 x 107 mL-1 whole blood/dayHemoglobin concentrationLeukocytes0.335 g mL-1 of erythrocyteCount-7.4 x 106 mL-' whole bloodDiameter7-20 µmPlateletsCount-2.8 x 10° mL-' whole bloodDiameter-2-5 µm

The properties are given in the table.

Whole Blood pH 7.35–7.40 Viscosity (37°C) 3.0 cP (at high shear rates) Specific gravity (25/4°C) 1.056 Venous hematocrit-male 0.47 Venous hematocrit-female 0.42 Whole blood volume -78 mL kg-' body weight Plasma or Serum

Whole Blood pH 7.35–7.40 Viscosity (37°C) 3.0 cP (at high shear rates) Specific gravity (25/4°C) 1.056 Venous hematocrit-male 0.47 Venous hematocrit-female 0.42 Whole blood volume -78 mL kg-' body weight Plasma or Serum

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A certain gas at temperature equivalent to 24 degrees Celsius at 8 cu.m and 200 kPa is compressed to 3 cu.m, what is the resulting pressure assuming isothermal conditions in kPa abs? O 457.14 O 360.00 O 640.00 O 533.33
Determine the blade length for a wind turbine that supplies an electrical power output of 1.95 MW and given the following parameters: Wind speed = 51 km/hr The gear, generator and electric efficiencies are 93%, 95% and 91% respectively. The power coefficient of the wind turbine is the maximum possible as given by the Lanchester-Betz limit. Assume the atmospheric air conditions are 1.01325 bar and 27 °C
4. Consider the branched pipe flow shown below used to transport water. Locations 1, 2, and 3 are equipped with pressure gauges that measure interior pressures. Inlet P1 Outlet P2 P3 Telepon sa Outlet Total volumetric flow rate at the inlet (1) is 0.27 m³/s. The diameter at location 1, 2, and 3 are 12.5 cm, 10 cm, and 7.5 cm, respectively. Pressure gauges 1 and 3 read 1.7 atm and 1.36 atm, respectively. Estimate the pressure pz. All three branches are in a horizontal plane. Neglect friction losses.
100 10 Circular disk Sphere 0.1 0.01 1 10 100 1,000 10,000 100,000 1,000,000 10,000,000 Reynolds number Re = U d/v A spherical weather balloon of 2 m diameter is filled with hydrogen. The total mass of the balloon skin and the instruments it carries is 3.7 kg. At a certain altitude the density of air is 1.0 kg/m3 and is 10 times the density of hydrogen in the balloon; the viscosity of air is 1.8x10-5 Ns/m3. Determine the steady upward velocity of the balloon. m/s Drag coefficlent Ca
(b) An experimental balloon filled with helium is equipped with meteorological instruments is released to the atmosphere from sea level. Measurement data was analysed to derive the linear temperature lapse rate up to high altitudes above sea level. The lapse rate was found to be equal to 0.0065 K/m. Estimate the altitude of the balloon above sea level when the atmospheric pressure is equal to 60 kPa. Atmospheric temperature and pressure at sea level may be assumed to be equal to 15°C and 101 kPa. Characteristic gas constant is 287J/kgK.
Saturated steam at 99.6 °C is heated to 350°C. Use the steam table provided to determine: a. The required heat input if 1 kg of steam undergoes the process in a variable-volume constant-pressure container. b. The work of expansion (in kJ) of the steam undergoing the process. C. The required heat input if a continuous stream flowing at 1 kg/s undergoes the process at constant pressure. d. Does your numeric answer to part c equal the sum of parts b and a? Explain why or why not. Given: 1 bar = 10 N/m4, Q= AH, Q = AU, AA = AÛ + PAV, table B.7 in kJ/kg and m/kg.
QUESTION 1 Three pipes A, B, and C are interconnected as shown in figure 1. The pipe dimensions are as follows: D (cm) 15 10 20 Pipeline L (m) 300 0.01 B 240 600 0.01 0.005 A 15 m 25 m B Figure 1 1.1 Find the rate at which water will flow in each pipe, ignoring the shock losses at P and entry to pipelines A and B. 1.2 Find the pressure at P.
Pi constant to be used: 3.14159 Capillary tube: radius = 0.02 cm; length = 9 cm; pressure = 0.7 mmHg Liquid sample: density = 4 ml; time of flow = 4.5 seconds Determine (a) pressure in MKS unit, (b) pressure in CGS unit, (c) the viscosity of the liquid, (d) If the weight was given as 8.5 grams, what will be the density of the liquid? (e) the kinematic viscosity of the liquid? (f) and the fluidity of the liquid?
A pressure gauge at elevation 8 m at the side of a tank containing a liquid reads 80 kPa. Another gauge at elevation 4 m reads 120 kPa. Compute for the Density a. 4077.47 kg/m^3 b. 815.49 kg/m^3 c. 1019.37 kg/m^3 d. 5096.84 kg/m^3
A rock 10 cm long and 2 cm^2 in cross section lows 0.0080cm/sec of 2.5 cp oil under a 1.5 atm pressure drop. 1. If the oil saturated rock 100% what's the absolute permeability?
1. A capillary tube is being used to measure the viscosity of a Newtonian liquid. The tube has a 4-cm diameter and a length of 20 cm. Estimate the viscosity coefficient for the liquid if a pressure of 2.5 kPa is required to maintain a flow rate of 1 kg/s. The liquid density is 998 kg/m3 2. Calculate the viscosity of a fluid that would allow a pressure drop of 35 kPa over a 5 – m length of 3.4 in. stainless steel sanitary pipe if the fluid is flowing at 0.12 m3/hr and has a density of 1010 kg/m3. Assume laminar flow. 3. At 2 cm diameter, 5 cm long capillary-tube viscometer is being used to measure viscosity of 10 – Pa.s liquid food. Determine the pressure required for measurement when a flow rate of 1 kg/min is desired and ρ= 1000 kg/m3.
The Reynold's number of a sphere falling in air is 1E6. If the sphere's radius is 1ft, what is its velocity? Density of air is 0.00234 slug/ft³ and viscosity of air is 3.8E-7 lbf-sec/ft²A. 2.5 ft/sB. 5.1 ft/sC. 40.6 ft/sD. 81.2 ft/s