You are given three unknown samples stored in screw-capped containers and was told to analyse them. You noted that Container A is cloudy and have some particles that are staying near the bottom of the container. Container B is translucent while Container C is transparent. If the contents of Container A can be separated by simple decantation,what is the particle size that BEST describes its composition? i. <1 nm ii. 1 nm iii. 1 nm-100 nm iv. >1000 nm

You are given three unknown samples stored in screw-capped containers and was told to analyse them. You noted that Container A is cloudy and have some particles that are staying near the bottom of the container. Container B is translucent while Container C is transparent. If the contents of Container A can be separated by simple decantation,what is the particle size that BEST describes its composition? i. <1 nm ii. 1 nm iii. 1 nm-100 nm iv. >1000 nm

Introductory Chemistry For Today

8th Edition

ISBN:9781285644561

Author:Seager

Publisher:Seager

Chapter7: Solutions And Colloids

Section: Chapter Questions

Problem 7.86E

See similar textbooks

Similar questions

ow do the properties of a nonhomogeneous (heterogeneous) mixture differ from those of a solution? Give two examples of nonhomogeneous mixtures.
KMnO4 and Na2C2O4 solutions were used in the reactions that took place in a back titration to determine the amount of H2O2 in a sample. Calculate the concentration of H2O2 in the sample (w / v) as% by making appropriate assumptions for the volumes and normality of all these solutions.
(a) A solution of 20.91 % by weight H2SO4 has a specific gravity of 1.150. What is the normality of this solution? (b) Water is added to dilute this solution to a solution of 3.03% by weight H2SO4 (SG= 1.020). What is the new normality of the resulting solution and how were they mixed? (Assume 100 mL of the original solution was used.)
1.) In the Dumas method for determining the molar mass of an unknown volatile liquid, a sample of a volatile liquid that boils below 100 oC is vaporized in a boiling water bath and the mass of the vapor required to fill the flask is determined. The following data was collected: Flask Volume 100.0 +100.0 + 79.6 mL = 279.6 mL Mass of Flask + Cap 143.85 g Mass of Flask + Condensed Liquid 144.95 g Mass of Condensed Liquid 1.10 g Temperature of Water Bath (oC) 84.1 oC Barometric Pressure (atm) 0.985 atm a.) What is the molar mass of the unknown? b.) What will its temperature be when the pressure is 1.20 atm and the volume is 250.0 mL?
If 10.0 mL of H2SO4 (sp. Gr. 1.50, containing 48.7% of combined SO3 by weight) is diluted to 400 mL, what is the normality of the solution as an acid? (b) What volume of 6.00 M H2SO4 should be added to this in order to make the resulting mixture 1.00N as an acid? FW's : H2SC4 = 98; SO3 = 80
You are required to prepare 5 L of a solution containing 1.000 x 103 mol/L of Cu2"(aq). Which of the following procedures would produce an appropriate solution? O Dissolve 0.0636 g of copper metal in nitric acid, add to a 5.000 Lvolumetric flask, dilute to the mark with deionized water and mix well. O Dissolve 1.248 g of CuSO.5H,0(s) in deionized water, add to a 5.000 L volumetric flask, dilute to the mark with deionized water and mix well. Dissolve 0.250 g of CUSO,.5H,O(s) in deionized water, add to a 5.000 L volumetric flask, dilute to the mark with deionized water and mix well.
b) A plot of land was explored and found to contain 1,000,000 grams of gold. The average goldconcentration was found to be 0.8 grams per ton. A mine was set up on it and sluice boxes were used as the main gold recovery units and recovered200,000 g of gold from 80% of the ore. The concentration ratio of the sluice boxes was 10,000.The field was mined again. On this occasion bowl concentrators were used. The feed used wasestimated to be 800,000 tons and the concentration ratio of this unit was 20,000. 750,000 grams ofgold was recovered. Calculate the following: i) the Quantity and grade concentrate from the sluice boxes .................. ..................... ii) the quantity and grade of the concentrate from the bowl concentrator plant. .............. iii) the quantity and grade of the material remaining at this location...................................
Exactly 1.00 grams of granular table salt was dissolved in deionized water up to 500 mL. An aliquot of 20 mL was titrated with AgNO3 (T = 8244 mg/mL) and consumed 46.60 mL to reach end point. If the impurities are just water, calculate the percent Moisture. Ans in 1 sig figure.
What weight of mercury bichloride should be taken as sample, assuming 100% purity, so that 0.5 g og HgS will be obtained in a gravimetric analysis? Gravimetric factor = 1.1669
(b) Potassium nitrate was synthesized in an experiment using 10 mL of nitric acid and excess potassium hydroxide. The mass data obtained from the experiment is shown in Table 1 below. Given that the percentage yield of potassium nitrate was 88.3 %, calculate the concentration (% m/v) of the nitric acid used in the experiment. Table 1: Mass data for the synthesis of potassium nitrate from nitric acid and potassium hydroxide Mass of clock glass and crystallized potassium nitrate/ 45.55 Mass of empty clock glass/ g 39.18
5. (optional) Blue turquoise is an example of a hydrate mineral containing copper; the chemical formula is CuAl6(PO4)4(OH)8•4H2Ó. What is the percent water in this semiprecious stone?
PAPER CROMATOGRAPHY • Define chromatography • Demonstrate an understanding of the process of chromatography • Describe the steps involved in a chromatography investigation Explanation Coloured inks are often made up of several different inks. Each colour of ink will get carried a different distance by the water, allowing you to see all of the different inks. Try this with different colours to see what actually goes into a colour. This technique is called chromatography and can be used in chemistry to find out what is in an unknown mixture. II. Materials .Felt tip pens (non-washable) . Kitchen roll .A bowl or cup . Water • Scissors III. Health and safety • Make sure that you thoroughly clean any equipment after the experiment before using for food IV. Procedure Method 1 1. Take a sheet of kitchen roll and draw a simple picture with a non-washable felt tip pen. 2. Place the sheet over an empty bowl. This is to keep the paper from getting too wet. 3. Carefully add a few drops of water…