Using complete diode model and assuming that the forward resistance of thediode is 152 and a Germanium diode, the voltage across the resistance R equals to R. 5kQ 12V 11.65 V 11.7 V 12 V None of the above

Using complete diode model and assuming that the forward resistance of thediode is 152 and a Germanium diode, the voltage across the resistance R equals to R. 5kQ 12V 11.65 V 11.7 V 12 V None of the above

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter59: Motor Startup And Troubleshooting Basics

Section: Chapter Questions

Problem 12SQ: How is a solid-state diode tested? Explain.

See similar textbooks

Related questions

Q: Question S- tor the Circuit shown below the Zener diode Joltage Uz=12v, Izk= 0-2mA, Izm =15MA, and…

A: Given:- VZ=VB=12vIZK=2mAIZm=15mA

Q: What is the difference between the outputs of the circuits (3.1 through 3.6) with ideal and silicon…

A: When Vin>0, the diode D1 acts as open circuit and remains off the output voltage is Vout=0 When…

Q: Find if the diode is conducting or not Silicon Diode with -1.3V on the Anode terminal and 2V on the…

A: Diode conducts only when it is forward biased i.e. anode terminal should be at higher potential than…

Q: 1. A Silicon diode is operating at a room temperature of 25 °C and has a reverse current of 10 nA.…

Q: Given the circuit below, What is the output voltage in volts on the positive half cycle of the…

A: In this question we need to find a output voltage in positive half cycle.

Q: etermine the voltage across the diode assuming a complete diode model.

A: Let's assume that diode is made by silicon semiconductor material. Its cutin voltage Vr= 0.7V Case 1…

Q: For the circuit shown, the Zener diode (with a breakdown voltage of 10 V) is in which region of…

Q: A pn diode has a resistivity of 1 Ω·cm on the p-type side and 0.02 Ω·cm on the n-type side. What is…

A: Given data; Resistivity for p-side = 1 Ω·cm Resistivity for n-side = 0.02 Ω·cm Cross sectional area…

Q: For the circuit shown, the Zener diode (with a breakdown voltage of v, = 10 V) is in which region of…

A: In this question, choose the correct option The region of the zener diode?

Q: Estimate the forward bias voltage of P-N diode, if a forward current of 9.75mA is flowing through…

Q: "Determine the de resistance in ohms of commercially available silicon diode at a forward current of…

A: The thermal voltage of the commercially available silicon diode at room temperature is, VT=26 mV…

Q: Determine the Anode to cathode voltage of a certain 4- layer diode which is biased in the forward-…

A: Given, 4-layer diode is in forward blocking mode. Anode current (Ia) = 2.5 uA Resistance of the…

Q: With the given circuit below, if the input voltage is 10 volts peak-to-peak and the diode is…

A: The diode is ON when the voltage across anode is more than the cathode voltage. It is known as…

Q: From the circuit below, 1.) Determine the current IRL flowing through the resistor RL. 2.)…

A: Given circuit:

Q: Using diode equation, find the p-n junction Germanium diode current for a forward bias of 0.2 V at…

Q: Q1: Using a piecewise linear diode models having an ideal diode, VB = 0.7 V, and Rp = 20 Q for each…

A: using a piece wise linear diode models having an ideal diode V B = 0.7V, R D = 20Ω for each diode…

Q: For the circuit shown, when the diode ideal, The value of Vout V. out 1 V 2 V= 3 V= 2 ΚΩ 2 ΚΩ

Q: Assuming an ideal diode model for all the diodes in the circuit below, chose the correct state…

A: Assuming ideal diodes means that in the forward biased condition, the voltage across the diodes will…

Q: How can you plot Vo versus Vi for diodes for Vi is less than or equal to 30V but greater or equal to…

Q: Assuming the diodes to be ideal. For the circuit shown below: (a) Find the transfer characteristics…

Q: Calculate the values of the diode resistance rd for a diode with IS = 1 fA operating at ID = 0, 50…

A: Given The saturation current of the diode IS=1 fA The diode current Q-point ID=0 The conductance of…

Q: a on junction diode is dissipating 0.5 W. If 5 V is applied across the diode( fb), then what is the…

A: The power dissipated is the product of the voltage applied across the diode and current flowing…

Q: 3. For the given circuits in below, a) Find the values of Vin, VD and ID for the cases where the…

A: Given a diode circuit with two different cases diode is ideal andS Silisium(VT = 0,7V). Frequency…

Q: Using diode equation, find the p-n junction diode current for a forward bias of 0.22V at room…

Q: diode with a voltage drop in the forward direction of 0.7V at 1.0mA and

Q: The Zener diode shown below, is specified to have Vz=2 Izk = 0.1mA, IzT = 17 mA, and r, = 14 N. Vcc=…

A: "Since you have posted a question with multiple subparts, we will solve the first three subparts for…

Q: For an ideal diode which of the following is true? a) It allows the passage of current in the…

A: In the following sections, among the given statements, which are true for an ideal diode will be…

Q: Problem-1 Apply the knowledge gained from diode theories to construct a clamper circuit that will…

A: Semiconductor are the material made of pure Si or Ge or compound . They have conductivity in between…

Q: Determine the voltage and the current of the diode in: a) First Approximation b.) Second…

A: Here, we have given a electric circuit, where we have to calculate the voltage and current of the…

Q: D1 D, vo 1 kN 1 kN D2 D1

A: First we will find out relationship between input and output voltage . Then we will draw output…

Q: Estimate the forward bias voltage of P-N diode if a forward current of 6mA is flowing through the…

A: In this question , we will find forward bias voltage of P-N diode with given data.....

Q: 0.48 0.97 4.45. 4.98 2.42 lo 20 25

Q: A diode is operating with iD = 300 μA and vD =0.75 V. (a) What is IS if n =1.07? (b) What is the…

A: Given iD=300 μAvD=0.75 V (a) If n=1.07 The expression for diode current is given by…

Q: Using complete diode model and assuming that the forwyd resistance of thediode is 152 and a…

Q: 2. Find the Q- point for the diodes in the circuits shown below. Assume that the Zener diode has Von…

A: For the above given question by identifying status of both the diodes we need to compute Q points of…

Q: Determine the minimum input voltage required for regulation to be established in the re. Assume an…

A: Here i have derived the answer.

Q: For the circuit shown, the Zener diode (with a breakdown voltage of vz : 10 V) is in which region of…

A: Find the region of zener diode for the given circuit ?

Q: Determine if the diode (ideal) is forward biased or reverse biased? Solve the voltage across the…

A: This question is belongs to applications of diode. This question requires basic knowledge about…

Q: For the circuit shown in the figure below, find the current passing through the circuit and the…

A: A diode is two terminal semiconductor device that is responsible for the unidirectional flow of…

Q: Assuming an ideal diode model for all the diodes in the circuit below, Calculate the voltage across…

A: When a voltage is applied across circuit., Diode D2 & D3 Become Short -Circuited and Diode D1…

Q: 4.62 A shunt regulator utilizing a zener diode with an incremental resistance of 102 is fed through…

Q: b) Extract and draw the voltage transfer relationship between vo and VI. VD = 0.7 V, assume input…

Q: Q/ Determine vo and the required PIV rating of each diode for the configuration of Fig 100 V Ideal…

A: The solution can be achieved as follows.

Q: What the range of values of Vi that will maintain the Zener diode in the "on" state. R "L + 220 Ω P…

Q: In a certain silicon diode, it was found that the diode current is 15mA when the diode voltage is…

Q: With the given circuit below, if the input voltage is 10 volts peak-to-peak and the diode is…

A: For the given circuit , to find the output voltage in the negative half cycle This is a negative…

Q: Determine the range of values of Vi that will maintain the Zener diode of in the "on" state. ... 220…

A: Zener diode maintains 20 volts when voltage across the zener diode exceeds 20 volts. Given maximum…

Q: Assuming an ideal diode model for all the diodes in the circuit below, Calculate the voltage across…

A: It is given that the given diodes are ideal ones. so we can say that if the diodes are forward…

Q: Q5: - For the circuit shown below, find the output waveform, output efficiency and required PIV.…

Q: In a certain silicon diode, it was found that the diode current is 15mA when the diode voltage is…

A: Here, we have a Si diode at room temperature. The diode current, ID1=15 mA The diode voltage,…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1 Explanation of question

VIEW

Step 2 Voltage across the resistance R

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Three Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is the difference between a diode and rectifier?
What is CEMF?
Hi! Please help me answer this problem our topic here is about Diode in DC & AC Circuits. Please show your correct and complete solution. ASAP! THANK YOUUU!
Determine the current I in the circuit (i). Assume the diodes to be of silicon and forward resistance of diodes to be zero.
True or False. Please explain. thank you As the temperature increases, the forward voltage decreases in a silicon diode. Then, the graph of the forward bias region will shift to the left.
The following circuit uses two Zener diodes with reverse breakdown voltage of 5.1 V for each. (1-a) Explain the operation of the Zener diode in forward and in reverse bias. (1-b) Analyze the circuit thoroughly assuming many source values that lead to all possible cases of diode states. For each case (Hint: 3 cases), re-plot the circuit and develop the relation between the output voltage and the source. (1-c) Draw input and output waveforms accurately over 0.5-ms period. Identify the diode states on the graph based on the categorization of cases from part (1-b). (1-d) Use Multisim to verify all of your results. Compare andcomment.
A silicon diode has 1 ampere DC of current in biasd mode. What is voltage drop across the diode?
(1-a) Explain the operation of the Zener diode in forward and in reverse bias. (1-b) Analyze the circuit thoroughly assuming many source values that lead to all possible cases of diode states. For each case (Hint: 3 cases), re-plot the circuit and develop the relation between the output voltage and the source. (1-c) Draw input and output waveforms accurately over 0.5-ms period. Identify the diode states on the graph based on the categorization of cases from part (1-b).
The diode from the following characteristic curve in Figure 1 was changed to zenerdiode. Determine: the function of zener diode in reverse biased. Briefly explain the differencebetween conventional diode and zener diode.
Determine the state of diode for the circuit shown and find ID, VD. Assume simplified model for the diode. 4k02 2V 1k02. Off, 0.00mA, 0.4V O Off, -0.005mA, 0.0v On, 0.48mA, 0.6v On, 0.55mA, 0.7v Option 5
consider the figure below that shows an approximated reverse recovery turn-off characteristics for a power diode. Show that the following relation can express the total reverse recovery charge, Qrr = 1/2(trr*ts1) di1/dt =1/2(trr*ts21) di2/dt * ip Isl 1s2! -Ir
0:- Consider the circuit in Figure a) What type of circuit is this? b) Find and Sketch the voltage waveform across RL, assume the diodes are practical. c) If 100uf capacitor parallel with the resistor, calculate the ripple is connected factor I O o D