The fork lift has a weight of 2,400 lb and a center of gravity at G. If the rear wheels are powered, whereas the front wheels are free to roll, determine the maximum number of 300-lb crates the fork lift can push forward. The coefficient of static friction between the wheels and the ground is μw = 0.4 and between the each crate and the ground μc = 0.35.

The fork lift has a weight of 2,400 lb and a center of gravity at G. If the rear wheels are powered, whereas the front wheels are free to roll, determine the maximum number of 300-lb crates the fork lift can push forward. The coefficient of static friction between the wheels and the ground is μw = 0.4 and between the each crate and the ground μc = 0.35.

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter7: Dry Friction

Section: Chapter Questions

Problem 7.19P: The 3600-lb car with rear Wheel drive is attempting to tow the 4500-lb crate. The center of gravity...

See similar textbooks

Similar questions

The brake pads at C and D are pressed against the cylinder by the spring BF. The coefficient of static friction between each pad and the cylinder is 0.15. Find the smallest tension in the spring that would prevent the cylinder from rotating when the clockwise couple M=2200lbin. is applied. Neglect the weights of the members.
The mass of the unbalanced disk is m, and its center of gravity is located at G. If the coefficient of static friction is 0.2 between the cylinder and the inclined surface, determine whether the cylinder can be at rest in the position shown. Note that the string AB is parallel to the incline.
The single-threaded screw of the floor jack has a pitch of 0.5 in. and a mean radius of 1.75 in. The angle of static friction is 8.5. (a) Determine the couple C that must be applied to the screw to start lifting a weight of 4000 lb. (b) What is the couple required to start lowering the weight?
The 3600-lb car with rear Wheel drive is attempting to tow the 4500-lb crate. The center of gravity of the car is at G, and the coefficients of static friction are 0.6 at B and 0.2 at C. Determine if the crate will slide.
The 40-lb spool is suspended from the hanger GA and rests against a vertical wall. The center of gravity of the spool is at G and the weight of the hanger is negligible. The wire wound around the hub of the spool is extracted by pulling its end with the force P. If the coefficient of static friction between the spool and the wall is 0.25, determine the smallest P that will extract the wire.
The 600-lb cable spool is placed on a frictionless spindle that has been driven into the ground. If the force required to start the spool rotating is F = 160 lb, determine the coefficient of friction between the ground and the spool. Neglect the diameter of the spindle compared to the diameter of the spool.
The screw of the clamp has a square thread of pitch 0.16 in. and a mean diameter of 0.6 in. The coefficient of static friction between the threads is 0.4. Determine (a) the torque C0 that must be applied to the screw in order to produce a 28-lb clamping force at A; and (b) the torque required to loosen the clamp.
The square-threaded screw 0f the C-clamp has a mean diameter of 8 mm and a pitch of 1.6 mm. The coefficient of static friction between the threads is 0.2. If the torque C=1.50Nm is used to tighten the clamp, determine (a) the clamping force; and (b) the torque required to loosen the clamp.
The drum has a weight of 110 lb and rests on the floor for which the coefficient of static friction is μs = 0.30. Assume the center of gravity of the drum is located at its center. Pt. A : If a = 3 ft and b = 4 ft, determine the smallest magnitude of the force P that will cause the drum to start sliding. Pt. B: If a = 3 ft and b = 4 ft, determine the smallest magnitude of the force P that will cause the drum to start tipping. Pt. C : Based on the results in the previous two parts, the impending motion of the drum is.... Slipping or Tipping?
The pickup truck pulls the wooden crate, as shown in Figure 2. The truck has a mass of 1.25 Mg and a center of mass at G. The coefficient of static friction between the truck's wheel and the ground is µ = 0.5, and between the wooden crate and the ground is µs' = 0.4. Determine the greatest weight of the wooden crate the pickup truck can pull if: a) the truck has rear-wheel drive while the front wheels are free to roll, and b) the truck has four-wheel drive.
The rope running over two fixed cylinders carries the 4-kg mass at one end. Determine the force P that must be applied to the other end to initiate motion. The coefficient of static friction between the rope and the cylinders is 0.15. 150 mm 150 mm 400 mm 4 kg O 64.1 N O 63.1 N 65.1 N O 62.1 N
Find the value s so that the worker can climb the ladder without causing it to slip. The weight of the worker is 90-kg and neglect the weight of the ladder. The ladder has a small roller at the top and at the ground the coefficient of static friction is 0.25. The center of mass of the worker is directly above her feet. B 4 m 1.5 m