Answered: using a variety of fluids. For which…

using a variety of fluids. For which fluid will the column of fluid in the barometer be the highest? 1. Mercury (p=13.6 x103 kg/m3) 2. Benzene (p=0.879 x103 kg/m3)

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter9: Fluids And Solids

Section: Chapter Questions

Problem 5CQ

See similar textbooks

Related questions

Q: In a mass spectrometer chlorine ions of mass 35u and 37u, each with charge +5e, are emitted from a…

Q: To determine the focal length f of a converging thin lens, you place a 4.00-mm - tall object a…

Q: Two ice skaters, Paula and Ricardo, initially at rest, push off from each other. Ricardo weighs more…

A: Law of conservation of momentum states that for two or more bodies in an isolated system acting upon…

Q: A large artery has a diameter of 7 mm. This artery divides into two identical smaller arteries, the…

Q: acceleration is 5m/s², determine the radius of curvature of the road.

A: The radius of curvature of the circular curved road can be found by following this…

Q: Momentum and Inelastic Collision Exercises (1) A car with mass 996 kg moving at 28 m/s hits a giant…

Q: Find the general indefinite integral. (Use C for the constant of integration.) √ (5-t) (2 + t²) dt

Q: Please refer to part (c). Here, the triangle is isosceles, and alpha (the angle at the top of the…

Q: Two jars of liquid have different temperatures, 77.7 °C and 21.6 °C. They are connected by a rod,…

Q: 8. A doubly ionized lithium atom has an electron in the n = 1 state. What is the kinetic energy of…

A: Atomic number of Lithium Z = 3 Electron is in n = 1 state

Q: The assembly shown in the figure below consists of a thin rod of length = 23.9 cm and mass m = 1.20…

Q: Part A- The acceleration due to gravity is equal to zero at the center of the earth.(True or False)…

Q: a- F. a у P a- a- X If a = 4 in, determine the moment of inertia about the x-axis located at point…

Q: One end of a massless, 30-cm-long spring with spring constant 25 N/m is attached to a 250 g…

Q: Consider a father pushing a child on a playground merry-go-round. The system has a moment of inertia…

Q: Find the expression for the magnetic field at point P in the wire configuration shown below. A…

Q: The figure shows (i) an X-ray tube, along with (ii) a graph of the X-ray intensity versus…

A: Target anode, Z=64

Q: 1) A single, Circular Loop of copper, with diameter 22.0 cm, is lying flat on this page. A 25.0-μT…

A: The magnetic field at the center of the circular current carrying loop is given by as the magnetic…

Q: The diameter of the nozzle is d 2 = 1 cm, and the diameter of the hose is d 1 = 3.8 cm. The volume…

Q: When work is done a system, it has a negative change in energy, and when work is done a system, it…

A: In thermodynamics, work is defined as the energy transfer that occurs due to a mechanical…

Q: re in the following equation if C₁ = 4.00 μF, C₂ = 6.50 μF, and C3 = 7.20 μF. Determine the value of…

A: The capacitance of each of the capacitors:To determine the value of Ceq (equivalent capacitance).

Q: The 23-cm-diameter disk in (Figure 1) can rotate on an axle through its center. For general…

A: In the question given figure is

Q: Should focal length be converted to meters from centimeters? If not, please tell me why not?

Q: A 1.00x104 kg railroad car is rolling at 6.00 m/s when a 4000 kg load of gravel is suddenly dropped…

Q: 1. Question 1: a. Draw a schematic of the hydrogen atom with the single proton in the nucleus, and…

Q: What is the minimum horizontal force F needed to make the box start moving in (Figure 1)? The…

Q: The range R and the maximum height H of a projectile fired at an inclination 0 to the horizontal…

Q: A resistor with resistance R and a capacitor with capacitance Care connected in series to an AC…

A: In a series circuit with a resistor and a capacitor connected to an AC voltage source, the total…

Q: How long does it take the Sun to melt a block of ice at 0 °C with a flat horizontal area 1.0 m² and…

A: Formula of Insolation energy is as follows:Formula energy required to melt ice is as follows:Mass of…

Q: Olaf is standing on a sheet of ice that covers the football stadium parking lot in Buffalo, New…

Q: A bullet of mass m is fired into a block of mass M that is at rest. The block, with the bullet…

Q: A solid 0.45 kg cylinder with a radius of 0.27 m is motionless at the top of a ramp and then rolls…

A: Given,Mass of cylinder, m = 0.45 kg Radius of cylinder, r = 0.27 m Initial linear velocity, v0 =…

Q: The figure provided shows a pendulum at an end point of its arc. Which statement below is true for…

A: A gravitational field without external forces, at the endpoint of its arc (highest point), the…

Q: A neutron with mass my moving with velocity vo collides elastically and head-on with a target…

Q: 0. When 1.4 x 105 J of energy is removed from 0.60 kg of water initially at 20 "C, will all the…

Q: Vectors A and B lie in the xy-plane. Vector A has a magnitude of 18.6 and is at an angle of 165.5°…

Q: Complete the following nuclear fission reaction of thorium-232. 232Th + n → 99Kr + 124Xe + ?…

Q: Calculate the resultant ground reaction force during the inital contact phase (to the nearest whole…

Q: A hinged metal boom arm (mass 58 kg) is holding a weight at the end of the arm (see below). A cable…

Q: tionary 1.2 kg steel ball B. After the collision. steel ball A is moving at 3.3 m/s [E 30°

Q: In the above figure, theta (the angle the incident ray makes with respect to the vertical) is 26.0…

Q: A ball of 85 grams is fired at a pendulum of 480 grams and is captured like the conservation of…

Q: A ball is thrown upward from the top of a 6 feet tall platform. The ball is 30 feet off the ground…

A: At time t=0, the height of the ball, At time t=1s, the height of the ball, At time t=2s, the height…

Q: 9. If 1,700 J of heat was added to the gas in problem 8, then how much did the internal energy of…

A: The work done (W) by an ideal gas during expansion or compression at constant pressure (P) can be…

Q: A cylinder having a mass of 200 kg is to be supported by the cord that wraps over the pipe.…

Q: A long wire of current I and a thin rectangular copper loop lie in the plane of the page. If the…

Q: 1. A wheel has a radius of 4.1-m. What distance across the flat ground will the wheel travel if is…

Q: In the figure below, the masses of each object are: m₁ = 1.00 kg, m₂ = 4.00 kg, m3 = 6.00 kg. The…

A: Calculate the x coordinate of the center of mass.

Q: A tank of gasoline (n = 1.40) is open to the air (n = 1.00). A thin film of liquid floats on the…

Q: A sun's rays are vertical at the point A on a planet. At the point B, which is 5574 miles due…

Question

Several common barometers are built using a variety of fluids. For which fluid will the column of fluid in the barometer be the highest?

1. Mercury (p=13.6 x10³ kg/m³)

2. Benzene (p=0.879 x10³ kg/m³)

3. Water (p=1.00 x10³ kg/m³)

4. Ethyl Alcohol (p=0.806 x10³ kg/m³)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Write the given values

VIEW

Step 2: Finding the required answer

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Pressure in the spinal fluid is measured as shown in Figure 11.43. If the pressure in the spinal fluid is 10.0 mm Hg: (a) What is the reading of the water manometer in cm water? (b) What is the reading if the person sits up, placing the top of the fluid 60 cm above the tap? The fluid density is 1.05 g/mL. Figure 11.43 A water manometer used to measure pressure in the spinal fluid. The height of the fluid in the manometer is measured relative to the spinal column, and the manometer is open to the atmosphere. The measured pressure will be considerably greater if the person sits up.
Figure P15.52 shows a Venturi meter, which may be used to measure the speed of a fluid. It consists of a Venturi tube through which the fluid moves and a manometer used to measure the pressure difference between regions 1 and 2. The fluid of density tube moves from left to right in the Venturi tube. Its speed in region 1 is v1, and its speed in region 2 is v2. The necks cross-sectional area is A2, and the cross-sectional area of the rest of the tube is A1. The manometer contains a fluid of density mano. a. Do you expect the fluid to be higher on the left side or the right side of the manometer? b. The speed v2 of the fluid in the neck comes from measuring the difference between the heights (yR yL) of the fluid on the two sides of manometer. Derive an expression for v2 in terms of (yR yL), A1, A2, tube, and mano. FIGURE P15.52
(a) What is the fluid speed in a fire hose with a 9.00-cm diameter carrying 80.0 L of water per second? (b) What is the flow rate in cubic meters per second? (c) Would your answers be different if salt water replaced the fresh water in the fire hose?
If your body has a density of 995 kg/m3, what fraction of you will be submerged when floating gently in: (a) Freshwater? (b) Salt water, which has a density of 1027 kg/m3?
Fluid originally flows through a tube at a rate of 100 cm3/s. To illustrate the sensitivity of flow rate to various factors, calculate the new flow rate for the following changes with all other factors remaining the same as in the original conditions. (a) Pressure difference increases by a factor of 1.50. (b) A new fluid with 3.00 times greater viscosity is substituted. (c) The tube is replaced by one having 4.00 times the length. (d) Another tube is used with a radius 0.100 times the original. (e) Yet another tube is substituted with a radius 0.100 times the original and half the length, and the pressure difference is increased by a factor of 1.50.
Liquid toxic waste with a density of 1752 kg/m3 is flowing through a section of pipe with a radius of 0.312 m at a velocity of 1.64 m/s. a. What is the velocity of the waste after it goes through a constriction and enters a second section of pipe with a radius of 0.222 m? b. If the waste is under a pressure of 850,000 Pa in the first section of pipe, what is the pressure in the second (constricted) section of pipe?
Figure P9.27 shows the essential parts of a hydraulic brake system. The area of the piston in the master cylinder is 1.8 cm2 and that of the piston in the brake cylinder is 6.4 cm2. The coefficient of friction between shoe and wheel drum is 0.50. If the wheel has a radius of 34 cm, determine the frictional torque about the axle when a force of 44 N is exerted on the brake pedal. Figure P9.27
Figure 11.35(a) shows the effect of tube radius on the height to which capillary action can raise a fluid. (a) Calculate the height h for water in a glass tube with a radius of 0.900 cm—a rather large tube like the one on the left. (b) What is the radius of the glass tube on the right if it raises water to 4.00 cm?
Water is moving at a velocity of 2.00 m/s through a hose with an internal diameter of 1.60 cm. (a) What is the flow rate in liters per second? (b) The fluid velocity in this hose's nozzle is 15.0 m/s. What is the nozzle's inside diameter?
. A juniper-wood plank measuring 0.25 ft by 1 ft by 16 ft is totally submerged in water, (a) What is its weight? (b) What is the buoyant force acting on it? (c) What is the size and the direction of the net force on it?
Gasoline is piped underground from refineries to major users. The flow rate is 3.00102 m3/s (about 500 gal/ min), the viscosity of gasoline is 1.00103 (N/m2) s, and its density is 680 kg/m3. (a) What minimum diameter must the pipe have if the Reynolds number is to be less than 2000? (b) What pressure difference must be maintained along each kilometer of the pipe to maintain this flow rate?