A ski resort chair lift has towers spaced 38 m horizontaly appart. The upper tower is 13 m higher than the previous tower. If the chairs are 12 m horizontally appart and the first chair is 5 m past the lower tower what is the tension on both ends of the cable? The mass of each chair is 550 Kg and the height above the lower tower for each chair's attachment to the cable is 0.26829 m, 3 m, 7.8195 m. Lower Tower Cable Tension = Upper Tower Cable Tension = kN. KN.

A ski resort chair lift has towers spaced 38 m horizontaly appart. The upper tower is 13 m higher than the previous tower. If the chairs are 12 m horizontally appart and the first chair is 5 m past the lower tower what is the tension on both ends of the cable? The mass of each chair is 550 Kg and the height above the lower tower for each chair's attachment to the cable is 0.26829 m, 3 m, 7.8195 m. Lower Tower Cable Tension = Upper Tower Cable Tension = kN. KN.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

4 A ski resort chair lift has towers spaced 38 m horizontaly appart. The upper tower is 15 m higher than the previous tower. If the chairs are 12 m horizontally appart and the first chair is 5 m past the lower tower what is the tension on both ends of the cable? 1:37:01 Book The mass of each chair is 350 Kg and the height above the lower tower for each chair's attachment to the cable is 0.58537 m, 4 m, 9.4244 m. Lower Tower Cable Tension = Upper Tower Cable Tension = kN. KN.
A 50 kg pole extends up a wall, making a 60° angle with the wall. The pole is supported by acable attached 3/4 of the way along the pole. This support cable is perpendicular to the wall.A 10 kg sign hangs from the end of the pole. The pole’s center of mass is 1/3 of the way fromthe wall to the end of the pole. (a) What is the tension in the cable?(b) What are the x and y components of the force the wall exerts on the pole?You must include an extended free body diagram showing all forces acting on the pole. Labelthe location on the pole you will use a reference for measuring distances (the “axis of rotation”) at the point where the pole touches the wall. Thank you!
Two blocks are connected by a (massless) string that passes over a (massless, frictionless) pulley as shown. Assume the interface between block A and the horizontal tabletop to be frictionless. pulley If mA = 6.3 kg and mg = 8.8 kg, what is the tension in the string? Express your answer in N, to at least one digit after the decimal point.
The spring clamp of Fig. block Fagainst the floor. The force in the spring is F = k(e – lo), where e is the present length of the spring, lo = 3 in. is the unstretched length of the spring, and k = 240 lb/ft is the spring constant. Determine all forces acting on mem- ber ÁBC of the spring clamp and the force exerted by the spring clamp on the block E. is used to hold the 8 in. D E 8 in. 6 in -6 in.- 6 in.
A sled with a mass of 25.0 kg rests on a horizontal sheet of essentially frictionless ice. It is attached by a 5.00-m rope to a post set in the ice. Once given a push, the sled revolves uniformly in a circle around the post as shown in the figure. If the sled makes five complete revolutions every minute, find the force F exerted on it by the cord. R-
The cylinders in the figure shown are piled in a rectangular ditch as shown. The radii of cylinders A,B and C are 4m , 6m, and 5m respectively. Neglecting the friction. Determine the reaction between the wall and B in kN.
Situation 6 - The 360-N box is held in place on the smooth inclined surface by the rope AB. Determine the following: 16. The tension in the rope in N. Answer: 318.44 N 17. The normal force exerted on the box by $30 the inclined surface, in N. Answer: 390.62 N 509 Flgure AP-4.16
Stiller Düzenleme 2) A uniform brass plate with area of 18 x 18 m? has mass of 41 kg which is hold by three Üst B cables in the horizontal position as shown. Please calculate the tension in each cable. B. 6 m. 9 m. 12 m. 9 m. ANSWERS TA (N) (10 pts) Te (N) (5 pts) Tc (N) (5 pts) F8 F9 F10 F11 F12 Insert Prnts HILO 8.
The figure below shows a painting hanging from a nail fixed into the wall. The picture is supported by a strong, light string attached to the picture symmetrically at two points along the top of the frame. 0.1 m 420 42 05 m 0.75 m Draw a free-body diagram of the painting. If the tension in the string is 60 N, what is the weight of the painting? A person tries to move the painting to the right by pushing on the bottom left edge with a force of 10 N. What moment does this exert about the nail? What force would the person need to apply to the top left edge instead to exert the same moment?
A uniform 80.0 N ladder 4.0 m long is placed against a frictionless wall with its base situated 2.0 m from the wall. Find the forces exerted by the wall and by the ground on the ladder.
Kindly include a Free body diagram.The 4.00 m boom is uniform and weighs 2550 N. Find the tension in the guy wire and the force exerted on the boom at its lower end.
The figure shows the Russel fracture traction device and a mechanical model of the leg. The leg is held in balance in the position indicated by the two weights attached to the two cables. The combined weight of the leg and cast is W=180 N. The horizontal distance between points A and B where the cables are attached to the leg is L=100 cm and the vertical distance is d=5 cm. Point C is the center of gravity of the cast and leg at three quarters of the L measured from point A (3L/4= 75 cm). The angle that cable 2 makes with the horizontal is measured as β=30°. Accordingly, in order for the leg to remain in balance in the shown position; a) Find the tensile force T1 in cable 1. (Write your result in N) Answerb) Find the tensile force T2 in cable 2. (Write your result in N) Answerc) Find the angle α of cable 1 with the horizontal. Response